Protective case that covers the front and back of the body in the case of PS Vita Polycarbonate. Can be played while wearing, also features a simple stand. Colours are clear blue, clear black, there are three clear colors, but this time I use the Clear Black.
The case of two parts attached to the front and back of PS Vita, making it a secure lid to lock in the bottom. And light weight is about 32g, which is the case for protection and performance-oriented thickness of about 1.4mm. So many openings, but the navigation keys and the front, ○ / △ / □ / × buttons, dual analog sticks, start / select button, PS button, speaker holes, openings are part of the front camera.
Looking at the side or rear, L / R buttons, rear touchpad, power switch, volume up / down, multi-use terminal, earphone terminal, which is only to touch the memory card slot. It can also be charged for using a multi-use terminal while still attached to the case.
In addition, the terminal part and accessory card slots PS Vita, if covered with a lid for closing the case, when you touch the two locations that will lift the lid. When opening the lid on the sides but on the display screen wobble a bit, that would be no disconnected parts. But basically that is described in the product page to use to close the lid.
The only, only SIM card slot on the PS Vita touch with the 3G version will not remove completely the case, this would not be where I would feel like not a touch so often.
Try using the PS Vita equipped with a real case, but a large open area, and forming a high sense of unity is solid, well matching the position of the device.
Case has a thickness of about 1mm or so, when disengaged and feel will vary considerably. Cover cases where a recessed rear left and right, but especially large changes in the sense of place and hold, that impression has not felt much harder.
The case itself is less obvious finger marks. Float part because when you put a statement on the touch pad has a thickness of the back-case, happens to be happy than not hesitate to put it off with nothing.
About the touch of a button, the opening edge portion of the operation is processed because it is equipped with a rounded thin, hard to manipulate them and hit the edge of the case do not feel your fingers. However, only the Start / Select buttons become little toes pressed in such a state. The same goes for the PS button.
Came to mind as well is still there on the fixing of the lid. Double trouble because it opens the lid of the case and the slot cover to protect the PS Vita card replacement annoying. That's tough style that I often swap the card in the main package version.
In addition, care would have pointed near the rear edge of the case L / R buttons. Been hit the tip of your index finger placed in the L / R buttons, there is a stimulus to the finger.
Finally, the stand features simple. This is open to the outside retaining the locking side, but it is placed upright to traverse PS Vita. It lay very simple so can not be made, the angle is 110 degrees and higher. I feel somewhat precarious stability but there, enough to be used for viewing and movies.
In the case felt that the openings are designed to increase the sense of unity, but overall quality is high, there is a place that you're using some care. I have become cumbersome, especially access to the card slots PS Vita people would choose.
